ROUND MID PEGS - GENERATOR

• Made to fit generator motors with open + closed tin primary's with 1.5" belt or stock chain drive

  • designed around my personal panhead utilizing a 1.5” open belt with a bit of room to spare

  • larger belt setups *may* require some DIY modifications

• Mount directly to your factory floorboard tabs - roughly 4” rise

  • HEADS UP: I cannot account for fitment on repop frames as they’re all made a bit differently. Generator side is a tight fit to begin with, if the angle is any different than OEM tabs then you will likely need to make some minor DIY modifications

• 5/8" mild steel solid round bar

  • raw/brushed

  • blackened patina

  • classic rust patina

**These are a made to order product, by just one dude…me! Although I can usually get them out the door within a few days, delays may occur. Please allow 1-2 weeks